基于三线性分灾模型的结构多目标抗震优化设计

基于分灾抗震设计概念,发展了基于三线性分灾模型的结构多目标优化设计方法。以防屈曲支撑为分灾构件的框架结构为例,针对分灾构件设计参数,采用多目标遗传算法进行分灾结构多目标优化设计。最终得到了分灾框架结构分灾构件用量和层间位移角等重要特性的多目标优化关系,并进行了相关讨论。结果表明,结构多目标分灾优化模型可以综合考虑结构造价和抗震性能等,并可以根据目标偏好有效地满足设计需求;分灾构件对抗震性能的作用随着震级增大而增强,使用分灾构件的结构能够更好地抵御强震的作用。     

波形钢板-UHPC组合桥面板结构截面优化

对实腹式波形顶板-UHPC(超高性能混凝土)组合桥面板进行了改进, 采用空腹式结构建立波形钢板-UHPC组合桥面板有限元模型, 研究UHPC层厚度、波形钢板厚度、波形长度、下缘板宽度和波形高度等截面参数变化对组合桥面板受力特性的影响, 并确定其合理取值范围. 在此基础上, 通过理想点法对参数组合进行优化, 得到合理的参数匹配. 研究结果表明 相较于实腹式组合桥面板, 优化后的组合桥面板自重减小35%, 钢板弯折处应力减小16%; 相较于正交异性钢桥面板, 桥面板用钢量减小7%, 顶板与U肋连接位置应力减小47%.     

The Application of Fractal Transform and Entropy for Improving Fault Tolerance and Load Balancing in Grid Computing Environments

This paper applies the entropy-based fractal indexing scheme that enables the grid environment for fast indexing and querying. It addresses the issue of fault tolerance and load balancing-based fractal management to make computational grids more effective and reliable. A fractal dimension of a cloud of points gives an estimate of the intrinsic dimensionality of the data in that space. The main drawback of this technique is the long computing time. The main contribution of the suggested work is to investigate the effect of fractal transform by adding R-tree index structure-based entropy to existing grid computing models to obtain a balanced infrastructure with minimal fault. In this regard, the presented work is going to extend the commonly scheduling algorithms that are built based on the physical grid structure to a reduced logical network. The objective of this logical network is to reduce the searching in the grid paths according to arrival time rate and path’s bandwidth with respect to load balance and fault tolerance, respectively. Furthermore, an optimization searching technique is utilized to enhance the grid performance by investigating the optimum number of nodes extracted from the logical grid. The experimental results indicated that the proposed model has better execution time, throughput, makespan, latency, load balancing, and success rate.     

Effects of ultrasound-assisted enzyme hydrolysis on the microstructure and physicochemical properties of okara fibers

This work focuses on the effects of different ultrasound power densities on the microstructural changes and physicochemical properties of okara fibers, which are composed of carbohydrate-based polymers. Okara suspensions were treated with ultrasound at different power densities (0, 1, 2, 3, 4, and 5 W/mL) for 30 min, after which the ultrasound-treated okara were hydrolyzed by trypsin to obtain okara fibers. The ultrasound treatment of the okara fibers induced structural disorganization and changes, evidenced mainly in their morphological characteristics and their relative crystallinity degrees. Increasing the ultrasound power broke the okara fibers into flaky and stacked structures. When the ultrasound power density reached 4 W/mL, the parenchyma became compact and the hourglass structure fractured. The mean particle size of the okara fiber was reduced from 82.24 µm to 53.96 µm, and the homogeneity was enhanced significantly. The relative crystallinity of the okara fibers was reduced from 55.14% to 36.47%. The okara fiber surface charge decreased when the ultrasound power was increased. However, after ultrasound treatment at 4 W/mL (800 W), the okara fiber suspension exhibited the highest viscosity value and a higher swelling capacity, water-holding capacity, and oil-holding capacity. Therefore, the results indicated that the selection of processing conditions for okara fibers is critical and that okara fiber modification using a high ultrasound treatment might improve their use in potential applications.     

Manothermosonication (MTS) treatment by a continuous-flow system: Effects on the degradation kinetics and microstructural characteristics of citrus pectin

Modified pectin (MP) was reported to have increased bioactivities compared with the original one. However, traditional modification methods such as using an acidic solvent with heating are not only costly but causing severe pollution as well. In this study, manothermosonication (MTS) with a continuous-flow system was utilized to modify citrus pectin. The citrus pectin (5 g/L) treated by MTS (3.23 W/mL, 400 kPa, 45 °C) exhibited lower molecular weight (Mw, 248.17 kDa) and PDI (2.76). The pectin treated by MTS (400 KPa, 45 °C, 5 min) exhibited a narrower Mw distribution and lowered more Mw (48.8%) than the ultrasound(US)-treated (23.8%). Pectin degradation data fitted well to kinetic model of 1/Mw_t −1/Mw₀ = kt (45–65 °C). A lower activation energy of 13.33 kJ/mol was observed in the MTS treatment compared with the US-treated (16.38 kJ/mol). The MTS-treated pectin lowered the degree of methoxylation (DM), mol% of rhamnose and galacturonic acid (GalA) while increased mol% of galactose (Gal), xylose (Xyl), and arabinose (Ara). The ¹H and ¹³C nuclear magnetic resonance showed that MTS could not alter the primary structures of citrus pectin. However, an elevated (Gal + Ara)/Rha and reduced GalA/(Rha + Ara + Gal + Xyl) molar ratios after MTS suggested that MTS resulted in more significant degradation on the main chains and less on the side chains of pectin, in agreement with the result of atomic force microscope. Moreover, the MTS-treated pectin exhibited a higher 1,1-diphenyl-2picryl hydrazyl radical scavenging capacity compared with original pectin.     

Ce掺杂6H-SiC电子结构和光学性质的第一性原理研究

采用基于密度泛函理论的第一性原理计算方法,对未掺杂及Ce掺杂6H-SiC的电子结构和光学性质进行理论计算.计算结果表明,未掺杂6H-SiC是间接带隙半导体,其禁带宽度为2.045 eV,掺杂Ce元素,带隙宽度下降为0.812 eV.未掺杂6H-SiC在价带的低能区,Si-3s、C-2s电子轨道对态密度的贡献较大,在价带的高能区,主要是由Si-3p、Si-3s、C-2p态组成.掺杂后Ce原子的4f轨道主要贡献在导带部分,掺杂后电导率提高.未掺杂时,只有一个介电峰,是价带电子跃迁到导带电子所致,掺杂后有两个介电峰,第一个介电峰是由于导带电子跃迁到Ce原子4f轨道上产生,第二个峰是价带电子向导带电子跃迁产生.未掺杂6H-SiC,在能量为10.31 eV处吸收系数达到最大值,掺杂后在能量为6.57 eV处,吸收系数达到最大值.     

Ultrasound-aided rapid and enhanced adsorption of anionic dyes from binary dye matrix onto novel hematite/polyaniline nanocomposite: Response surface methodology optimization

In recent times, polyaniline (PANI), a conducting polymer, has been studied widely for environmental remediation application due to its controllable electric conductivity with high surface area, which makes it a suitable adsorbent material. But lower mechanical stability of PANI is considered to be a serious drawback for its large-scale industrial application. To improve the mechanical strength of PANI, in this study, hematite nanoparticles were impregnated onto PANI by oxidative polymerization method in order to fabricate a novel organometallic nanocomposite (hematite-PANI-NC). The hematite-PANI-NC was used as adsorbent for removal of methyl orange (MO) and eosin yellow (EY) dye from binary dye matrix under ultrasonic-assisted adsorption. Excellent MO and EY dye removal (more than 98%) was observed from binary matrix at a wide solution pH from 2.0 to 6.0, and under ultrasound wave the adsorption equilibrium was achieved within 15 min only. Both MO and EY dyes adsorption experimental data strictly followed Langmuir isotherm, and maximum monolayer adsorption capacity of 126.58 mg/g and 112.36 mg/g was observed for MO and EY dye, respectively. The uptake mechanism of MO and EY dyes onto hematite-PANI-NC is governed by electrostatic interaction, π-π bonding and hydrogen bonding between dye molecules and nanocomposite. Response surface methodology analysis reveals maximum MO and EY removal of 98.43% and 99.35% at optimum experimental conditions. This study implies that the hybrid organometallic material hematite-PANI-NC has high potential for quick and enhanced sono-assisted uptake of anionic dyes from water near neutral solution pH.     

Synthesis,Characterization and Evaluation of the Antibacterial and Antitumor Activity of HalogenatedSalen Copper (II) Complexes derived from Camphoric Acid

Platinum metal complexes are the most common chemotherapeutics currently used in cancer treatment. However, the frequent adverse effects, as well as acquired resistance by tumor cells, urge the development of effective alternatives. In the recent past, copper complexes with Schiff base ligands have emerged as good alternatives, showing interesting results. Accordingly, and in continuation of previous studies in this area, three new camphoric acid-derived halogenated salen ligands and their corresponding Cu (II) complexes were synthesized and their antitumor activity was evaluated in order to determine the influence of the type and number of halogens present (Br, Cl). The in vitro cytotoxic activity was screened against colorectal WiDr and LS1034 and against breast MCF-7 and HCC1806 cancer cell lines. The results proved the halogenated complexes to be very efficient, the tetrachlorinated Cu (II) complex being the most promising, presenting IC₅₀ of 0.63–1.09 μM for the cell lines studied. The complex also shows selectivity to colorectal cancer cells compared to non-tumor colon cells. It is worth highlighting that the tetrachlorinated Cu (II) complex, our most efficient complex, shows a significantly more powerful antitumor effect than the reference drugs currently used in conventional chemotherapy. The halogenated salen and corresponding complexes were also screened for their antimicrobial activity against four bacterial species-Staphylococcus aureus, Enterococcus faecalis, Escherichia coli and Pseudomonas aeruginosa-and four fungal species-Candida albicans, Candida glabrata, Aspergillus fumigatus and Alternaria alternata. The compounds were found to exhibit moderate to strong antibacterial activity against the bacterial strains studied. NMR studies and theoretical calculations provided some insight into the structure of the ligands and copper complexes. Considering the results presented herein, our work validates the potential use of copper-based chemotherapeutics as alternatives for cancer treatment.     

Silver(I) Complexes of Two Flexible Bis-phospholane Ligands: Metallamacrocycles,Polymeric Chains,and Metallacryptands

In a 2:2 reaction with silver(I) chloride or bromide, 1,5-bis(1-phospholano)pentane ( 1a ) afforded frame-like macrocyclic structures, with intra- ( 2 , Cl) or intermolecular ( 3 , Br) halido bridges. In contrast, 1,7-bis(1-phospholano)heptane ( 1b ) formed coordination polymers 4a (Cl) and 4b (Br) with bridging bis-phospholane and halido ligands. A unique paddle wheel-type metallacryptand structure 5 was obtained from 1a and silver(I) bromide in a 2:3 reaction (M:L). All complexes were fully characterized by NMR, IR spectroscopy, mass spectrometry, and X-ray crystallography.     

Synthesis,Structure, and DFT Analysis of the THF Solvate of 2-Picolyllithium: A 2-Picolyllithium Solvate with Significant Carbanionic Character

Previous studies of different solvates of 2-methylpyridyllithium (2-picolyllithium) have uncovered electronic structures corresponding to aza-allyl and enamido resonance forms of the metallated pyridine-based compounds. Here, we report the synthesis and characterization of [2-CH₂Li(THF)₂C₅H₄N], a new THF solvate. X-ray crystallographic studies reveal a dimeric arrangement featuring a non-planar eight-membered [NCCLi]₂ ring, in which the primary cation-anion interaction is between the central Li atom and the C atom of the deprotonated methyl group [length, 2.285(2) Å], suggesting a new carbanionic resonance structure for this 2-picolyllithium series. The significant carbanionic character of [2-CH₂Li(THF)₂C₅H₄N] was confirmed by gas-phase DFT calculations [B3LYP/6-311+G(d)] with the calculated electron density interrogated by means of quantum theory of atoms in molecules (QTAIM) and natural bond orbital (NBO) analyses. For comparison these computational analyses were also performed on the literature structures of [2-CH₂Li(2-Picoline)C₅H₄N] and [2-CH₂Li(PMDETA)C₅H₄N]. In a reactivity study, [2-CH₂Li(THF)₂C₅H₄N] was found to undergo nucleophilic addition to pyridine to generate dipyridylmethane in a good yield.